The Jalopy Journal
Does anyone know if there is a HIGH FLOW option for the dodge 230 flat 6 engine? my block is 1953. I have seen someone rebuild them so that they...
update: had to have crank turned .40 over, also had the connecting rod journals .40 over. found all the bearings needed and now that I have used a...
There is a guy I found one time who rebuilds oil pump's for the Dodge 230 flat head 6. He was said that he would tighten them up and make them...
yeah man, I was stoked that when it came out it was 1 piece. also, I think I just sourced the .30 main bearings and .20 rod bearings. things are...
UPDATE: was able to slide hammer out the water jacket in the block which came out in one piece (thankfully). I got the engine in the steam...
picture of inside the head after steam cleaning. [ATTACH]
The engine build is going good as well, I got the engine out and am now rebuilding it at the local community college that I attend for night...
The new transmission looks great, 3 speed with the 6 volt overdrive. I will be installing the transmission onto the engine/bell housing before I...
Well its been a while since I have updated this post, I moved the build to the AACA site because a lot of those guys have the same car's and know...
I am rebuilding my engine in night school engine building class and cannot seem to find the engine spec's for this engine. can anyone help me with...
So I will fill grease fitting and then also run grease around and in with my hand, then clean off and see how it feels.
If I spin it, it makes sound, its for sure dry. you think if I grease it (which will take up the empty room where grease should go) it will be ok...
Separate names with a comma.