The Jalopy Journal
Yes, it is 15/16 sorry for my mistake. The master is below the floor and below the caliper. I will take a look at the master as you suggested to...
I did check for direction of flow on both residual valves, still same problem. I will give Wilwood a call to see if they have any idea or can...
yes, I did bench bleed.
Still working on my 30 Model A project and have a brake bleeding issue. It's a bit complicated to communicate but let me try. Brake Equipment:...
Need some help with my Headlight Housing. Thanks to some of you we determined that my headlight housing were Spun Brass. The housings have some...
Thanks for feedback, looks like oil level measurement may now raise its ugly head. I will give your idea a try and thanks again.
Thanks for the feedback and offer on the Bronco Pan. A friend has a 5.0 Mustang rear sump pan that I'm going to try. It has about the same...
Thanks for all your help I will check both your suggestions.
Thanks everyone for the feedback. Looks like my desire for a low stance coupe has some issues to be resolved, however I will overcome. I'm sure...
Yes, I think that is my best possible fix at this point. I measured a rear sump pan and it is about 6.5 in the front and 7.5 in the rear. This...
Yes, that is a possibility however my current pan is a cheap chrome pan so have to purchase a new one. Thanks for feedback.
Thanks for feedback will check it out
Separate names with a comma.