The Jalopy Journal
I have no place to store this coupe and its parts. It is up for sale, $2000. The body is very solid. It has a Mustang II front suspension with...
I have a T bucket that the tie rod is in the front and I doubt the akerman is correct. I did not build it and it is a shorter wheel base than the...
I am trying to use a 37 to 41 front axle under a square tube frame for a 30 tudor. I would like to put the tie rod out front to allow more room...
deleted, repetition.
Find you a T bucket frame and give it a home.
You may need to go past your marks. Think of it like tightening your front wheel bearings. With the ring gear in the way it is hard to feel the...
See, it does not say anything about carrying extra battery acid in the washer bottle.
You beat me to it. That is just on the west side of Birmingham off I-59
The master cyl push rod does not seem to be in line with the master cyl, so I am concluding you have a bell crank or another pivot arm making the...
this is what you want to work from. If you can find your cam card or get the info, it will tell you what rpm your tq peak is. I would try to run...
I guess if you disconnected the pump, you could fill it with something nice, like battery acid. There may even be some stains that are clear...
Sounds like the pivot points on the linkage are too tight.The long rod or rods running from the lower column to the trans arms should pivot at the...
I just scanned the thread and saw the magnet suggestion. If it was not mentioned the type of magnets used in computer hard drives, the name...
Separate names with a comma.