The Jalopy Journal
And all this time I thought you just posted on every thread...! :D Just messing with you 'beaner...
Pretty sure that is Gary Birns...previous owner of that Buick...couple threads on here about it...
Float sprung a leak, ... or crap in the needle seat, bowl overfull... my worthless 2 cents.
Weld em right to the top of your car, like they were duds dropped on you from high above....it will give the bullet hole sticker crowd a shock and...
Rattlecan
There is a bare set on the 'bay right now, in NY
Crud, now you got me wanting to pull a head off to give an accurate measure... I do have a compressed head gasket in the pile, pulled from the...
About 1/16" down the bore... I did not measure but that is a fair estimate (if my memory isn't failing me)... keep in mind mine is a 51 block...
Thank you for putting the effort forward in that spreadsheet... My aftermarket replacement 365 pistons came in as flat-tops, although I see...
the top half of the chart shows the stock stuff, the bottom half shows the resulting compression when you swap around diff years stock...
Just make sure you don't fill them full of boiling hot coffee and then grab them in the middle of the cylinder...use the 'insulated' plastic cap...
IMO, you need to find the source of the water getting into the oil before you can answer this Q.
The OPs original post said Estonia before... he changed it to EU...
Sorry, had to chuckle a little,...the OP is HAMB member #124....
Those are AWESOME! who repops them?
Separate names with a comma.