The Jalopy Journal
Also each stock 6 volt gauge needs a step down reducer if your running 12 volts. Another thought is (if you changed to a 12 volt fuel sender) make...
Stock box and linkage and correct oil pan that clears the steering linkage.
Trunk fill, run a one way vent/roll over valve from a filler neck to outside the trunk space.
They were dependable enough in the 30s to get to California during the dust bowl migration. Don't see they wouldn't be dependable enough to the...
Mine have a slight slope to them
Sorry I should have said height difference in the hoods.*
In the event you are talking about the rear splash valance and NOT what they mentioned above. Know there ARE different ones. Early 49s were...
Yes to BOTH!!!!
Want to make a STRAIGHT cut in a length of tubing or pipe with a handsaw? (& you don't have a miter box) Put a hose clamp on it to use as a guide.
Yes BUT you will have to drill new mounting holes for the different style hood hinges. I would get everything loosely bolted up. Then figure out...
I would suspect the thinking was to get the tumble more over the piston. instead of detonating with the mix mostly on the edge as Ive seen in...
Here in NC I run Goodyear super cushions w/4.25" ww on my 49. Looks great/fits great! Picked them up from Kelsey Tire in MO.
So deep you could swim in it! Killer!
I've known Todd and Leslie for along time. He was more than a club brother. (I moved in 2001 leaving the PR then. Pre-Greaserama era). Todd always...
Simple, use period correct hose clamps and firewall/frame rail clamps. Eelco thumb screws look good!
Separate names with a comma.
The Jalopy Journal