The Jalopy Journal
I am looking for Pontiac 8 lug drums. Don't need good or rebuildable lining. Prefer ones with RH lug nuts and fronts but would consider others....
hope she is doing well.
[ATTACH] [ATTACH] [ATTACH] I made these this past year for my shop. A HEAVY DUTY bead roller and a pullmax type mini-hammer.
CArbuilder, are you going to send the photos?
[ATTACH] This is the early Olds wheel that I used on my 34. It was made smaller in Dia and leather covered. I also did this back in 65 on my 57...
I have put an 61 Olds wheel on my 57 Ford pick-up years ago. What I did was cut off the Ford shaft and graft on the Olds shaft, below the top...
IMHO the Mustang II spindles are way too light weight!!! I don't like the fact they were on my 56 pick-up when it bought it. I mine only has the...
in June of 2010 I met them at the LA Roadster Show. Arranged for them to pick up my bumpers, headlight rings, and mirror brackets in Mesa, AZ....
a friend uses diesel fuel to spray down the underside of his motorhome.
If you are running it on the street you will have to either run a separate kill switch. A mag does not use 12 volt input. It needs a ground to...
Absolutely no advantage for street use. Made for racing. In fact the better ones for racing have a cable that allows the driver to fine tune the...
Yes, it is bolted to the floor. It will pivot around by loosening three set screws.
Since everything that bolts on seems to need three hours of machine work, my mill and lathe. If I could only have one welder, I would keep my...
If there is not a spring shop in you area, you can use a big hammer and a anvil. It just takes a long time. 'I think with a stock rear end you...
Separate names with a comma.