The Jalopy Journal
Anyone out there that is around 6' 2" ish that rides in a 30/31 coupe with 5" chop, 3" channel? Just want to know if I can get in one, don't care...
Good info....thanks
Im currently is the process of building a 31 coupe. I am building a SBC 350 and have been contemplating running a Joe Hunt magneto, not the...
Funny, I literally just went through this same thing last week. The 7201 only fit the port on the edelbrock head they are too big to fit a stock...
Can you run it that way? Yes. Is it as effective as a PCV? Probably not. The vacuum from the carb draws fresh air in through a vent (oil fill...
I've looked into the PCV quite a bit in the past month. I have always run one in the past without any thought and I was going to try and run my...
Thanks for the info. I am assuming coolant and thread sealer would control the electrolysis Sent from my iPhone using The H.A.M.B. mobile app
I have an edelbrock aluminum water pump going on a 350. I need to plug the heater provision holes in the water pump. I have a couple of aluminum...
I was really interested in the difference between the printoseal and the standard blue steel core when used with the aluminum intake and if it...
I recently installed an EDLbrock 3x2 aluminum intake to my SBC. The engine is a new GM 350 crate motor and the intake is new as well. I ordered...
OK, perfect...thank you. I wasn't sure if two breathers would have an adverse effect.....
Separate names with a comma.