The Jalopy Journal
37-40 cams are steel. That is the advantage for welding. I have some grinds in mind that I am pulling from my racing mower experience. PM Riley on...
Finished a 250 mile round trip shakedown run to Billet Proof 2013 at Don Garlitz's yesterday. Kept a steady 3000 rpm pace on the interstate system...
38 FLATTIE could you shed some light on what you mean by "We added material around the short side radius"? In the flathead singles I run in the...
Thanx 38Flattie I have been stalking your build for a few years. Still working on my own high RPM 322 LaSalle motor. Thanx for all the help Tom
Anyone know off the cuff the flat cad valve stem diameter and tip length. I know the lengths are 5 33/64 and dia is 1.876 -.886 intake and...
Shaved and welded in 47 heads to increase compression. Same thing we do for our racing mowers.
Any thought on this grind I am sending my LaSalle 322 camshaft to be done... it is a proven grind for flat heads with 8.1 compression.... with 265...
I know this an old post but I have had in incident that my oil pump locked up twisted off my distributor shaft. The issue is that the oil pump...
When are they available?? Thanx Tom
http://www.jalopyjournal.com/forum/album.php?albumid=7068&pictureid=64107 Did my 75 ford rims make me an enemy of the state of rodding?? If you...
72 Gold Duster with a 198 slant six 3 on the tree!! Still looking for a replacement!! Launched it one too many times playin' Dukes of Hazzard on...
Separate names with a comma.