The Jalopy Journal
Thanks! I think spindle or axle is bent a little. I will see if I can adjust it some. /Mike
Thanks JW! I remember that I mounted new bearings at driver side and it is that side the camber angle is more than the other side. Maybe I must do...
Thanks!
Yesterday I took the first test run with my Willys. She has been sleeping for 45 years and it was a great feeling to drive. The car acted as I...
Here is mine. Willys -38 Sedan, Chrysler 360 SB, 904 Aut., 81/4" rear end. Volvo Amazon front discs/hub on the original Willys spindles. Volvo...
It's alive! It's alive! I started up the engine for the first time in the Willys. My own manufactured open headers generates really great sound....
Finally I got my new flexplate for mopar 904 transmission (external ballance for sb 360"). I have begin to remove parts so only one screw hold the...
Hi David! The new firewall position is about 8" from its origin location. From the beginning I planned to have enough space to the origin fan, but...
Yes it is a Chrysler 360" SB. I'm using 904 Aut. gearbox and 81/4 rear end. Only Mopar stuff:) Boxed the frame at rear kickups and at the front at...
Nice work. The extra room for the distribuator is looking good. Keep up the good work. /Mike
Hi Tony! I also have done same mistake and throw away parts that I thougt I do not needed. Now I save all stuff I collect. My wife doesn't say...
Hi Tony! Yeah, I hope I get the flexplate this week so I can do a new attempt to start the engine. I looked for images of the column and its...
Have installed some electrical now. Battery shelf, fuse box, relays, start solenoid, cables etc. My intentions were to fire up the engine and...
Little more done... I have welded the fender. I also have done a support bearing for the steering column. I took suitable tough plastic material...
Hi Tony! Yes, I looked on your job with the radius and the result was very fine. I also looked on several other Willys and most of them I think...
Separate names with a comma.