The Jalopy Journal
Someone surprised me with these headlight housings as a gift. I'd love to give them a go but I would like to identify them if possible. Thank you...
It's just due to my familiarity with bronze. I haven't practiced as much with thin steel (I can do the razor trick with my TIG though.)
I have a question that I have to preface. I weld on bronze cast sculptures primarily using TIG. In some cases I have to weld on extremely thin...
So I take it that I can make a bracket in the cowl and bolt it to heavy brackets on the frame?
I've done multiple searches on the Googles and the HAMB and there's a detail with cowl steering that I seem to be missing. Using a Model A Sedan...
I found the needle bearings for next to nothing on Amazon. For as little as I paid for them I'm going to try them. Beats the crap out of buying a...
My problem is the spindle doesn't have enough space between the axle slot to put the stock bearing in between. When I upgraded to a solid kingpin...
Can you tell me how this worked? I'm in the same situation and have been looking at the needle bearings as an option.
I know this is an older thread, but I was curious if anyone had actually done this?
Fishplates are a definite. I'm going to put the front end together and then put them all on.
I'll likely make a new needle that can wrap around the gear.
This is a smaller thing I've done for down the road. This is a Harley Davidson speedo I've had for years on a shelf. I'd read somewhere that the...
So fast forward a bit. I had the rear suspension tacked up and ready to weld. The 4 bars, shock mounts and panhard were also ready to weld into...
Separate names with a comma.