The Jalopy Journal
I've fitted stainless louvers to f/glass engine boxes in marine applications. I tig 3/16 threaded studs at each corner of the louver, router the...
I'm just about to start another flat tappet motor. I received the cam and lifters from Crower at Xmas. I'm using a SD1 Rover alloy block...
That looks really cool. How much was the chop? I'm just starting on mine, I have a 10" chop and have mounted mine on a 1933 Willys chassis. I was...
Ran the compressor up today, temp at the copper tube from the pump into the antifreeze container was 76.5 degrees, at the copper tube into the air...
I run the air from my compressor direct into a coil of 3/8 copper tube in a 20 ltr (5gal) plastic paint container filled with a 50/50 mix of...
Wasn't me! But I keep a number of spring leaves and use them when I tune a spring. I have a leaf from a '37 Chev in the pack on the front of my T...
I noticed an outlet was warm when unplugging an extension cord. I turned the power off at the board and opened up the outlet, 2 of the screws,...
I have used an electric (AC) garage door unit that has the reverse already built in. I used an old bicycle sprockets and chain. I previously had...
Most of the ones I was thinking of were sans the front fenders, with modified/bobbed rear fenders. Doug Smiths 36 coupe, another 34 Tudor that was...
Actually, for where you are in New Zealand, there were a few early cars around the 60's early 70's that had quads and Flatheads, although the...
I use urethane on yachts, both inside and out. I use foam brushes, and only the Red Tree brand. Don't continually go over the urethane, this will...
I recently had the same problem with the hinges on my '27 T coupe. I used the impact but it shore the head of the screw so for the rest I placed a...
What grade are you using? Powdered BP seems to be more cost effective. Where do you purchase it from?
Should have been 429ci above, from a '64 Fleetwood
A really cool engine, I'm not sure a T5 will stand up to the torque of a 427 for very long. I'm running a T400 to a 3.55 rear with 235/85x16...
Separate names with a comma.