The Jalopy Journal
I haven't been around here in a long while, but glad to see the Hemi Tech archives are still up. I have a '55 331 (for the '55 300 model) that I...
Crap, I can't catch a break anywhere!
Now you have these! I have a Flamethrower III billet distributor for our Dodge 315 Poly I bought months ago with an intermediate shaft from Hot...
Had the same issue on my Dodge 315 Poly, but I cheated and bought the new shaft from Hot Heads. Was wondering if the shaft running flat up top...
I would also be interested in anyone's opinion on these guns that has used one. I have been looking into the Eastwood guns as well. Are they...
I think '55 and '57's are the same. Just so it points forward and upwards towards the radiator. There may be other years that will work, but, I...
I bought a Dodge thermostat housing off of eBay for our '56 Dodge 315V8 Poly and when I got it, it has 3 small pin holes in the neck where the...
I've read through this guys website a dozen times, really good stuff. Wish I could just have him build mine, but I don't have that kind of cash...
This was my first Nostalgia Drags and my son came along with me. This is a shot of him in the memorial front engine dragster that was there, he...
Is there an area where H.A.M.B. guys meet there? This will be my first one and would like to meet some guys from the Phx Valley area and see...
My young son and I will try to make it this year. Sounds like lots of fun!
Thanks George
Another early-to-later 331 question, but jumping to this thread. Can a dual-point distributor from an early 331 (say 51-53) Chrysler engine be...
Is there any problem in using a crank out of a '53 331 Hemi in a '55 C300 331 Hemi block? (of course assuming the crank is good)
Separate names with a comma.
The Jalopy Journal