The Jalopy Journal
Goop hand cleaner is a good start, won't mess up aluminum and if the goo is petroleum based it will start breaking it down. I actually use it...
Keep it simple, bailing wire, light braided steel cable with the crush connector, redo with webbing and big head rivets would be nice.
Hillbilly Knurl :D I've used it a lot, never on wheel bearing surface though.
Very good advice here, Dr and pacemaker manufacturer guidance. Now I'm wondering if an X Ray vest with lead liner would offer any additional...
Squirrel, Summit 1065 cam. 218 duration and .458 lift - I'm liking that - shorter duration than most at that lift.
I compiled factory SBC cam specs in a thread, others helped expand it....
Great to hear you're helping the family out, awesome score on the 57. The '73 truck - looks great to me. Scuff it down, acid etch, and shoot...
New clean stuff "sounds" nice. Getting it to mate together correctly takes some work. I'd start by confirming ( talking to) both the body and...
Speed bleeders and / or vacuum bleeder are worth the money, versus having to ask wife. I bought a mighty-vac, lasted awhile and the seals blew...
Was thinking same Hudson became AMC :D Olds / Buick / Pontiac 350 are usually priced low, everyone looking for larger version. Hudson with BOP...
Pulled from driving 67 buick wildcat convertible. 10.25 compression 360 hp, switch pitch trans. Freshen Up and mild upgrades, drive it.
I'm still here, engine is still sitting. :D I bought some parts for it, have future plans for it.
Single stage enamel is less nasty than urethane. The hardener for enamel is where isocyanates come in. If you reduce and spray without hardener...
Zinc or nickel plating may be an option.
I was hoping you'd see this post, its pretty local, you probably have half the parts to whip it into shape :D
Separate names with a comma.