The Jalopy Journal
Please....Please get out of my car. I'll give you whats left of my sandwich.
About ten yrs ago I was asked to design badges for a build. I drew it up in CAD and it was sent to a company that did EDM (Electrical Discharge...
I posted a deuce coupe back in post #786 that is now owned by a HAMBer. unfortunately my pic is gone and I can't find his thread. I don't think he...
Elvis has left the building! or at least one side of the caro_O Good on ya. Hope there will be a build thread.
Save $30+ by buying the included products separately. PC-7 = $13 @ Home depot SEM Plastic Prep = $22 @ local paint supply not really needed...
Lots of mostly good info. When it's broke flush or just a smidge down grab a flat washer and weld it hot to the bolt then weld a nut on top. I...
I've used Dynomat, Killmat, Noico and Siless. They are all 80 mil. butyl and neither I nor my customers can tell the difference between them. I...
I'll see your Continental and raise it a Zephyr with a 331 Cad.:D Rare 1941 Lincoln Zephyr Club Coupe - $2,800 (Austin)...
You do realize that #4 cable is NOT the same thing as 4/0 cable, which is a much larger diameter. #4 cable is what the factory likely used for...
@Pist-n-Broke That would only apply if there was a fulcrum involved @Ebbsspeed is correct. As mentioned the traction bar should make contact at...
Yep, It now says $37,500
First car that I did metal work on.(not this one) [IMG]
Factory stock cars are producing that now. (Dodge SRT demon 170 for example) It's not at all hard to to get that much HP nowadays $$$ Tech has...
Digging around in a old hard drive I found a link to this old thread. I got a couple right and remember some of the threads discussed. Never...
Awesome car and thread! I wish you luck in your continued search. I'm curious about the "loaded Oldsmobile engine" mentioned in the show program...
Separate names with a comma.
The Jalopy Journal