The Jalopy Journal
Same here. I cut as close to the line as I feel comftorable then use the cutoff wheel sorta like a grinding disc to just remove that last little...
Working on a friends aircooled motor I was using a timing light. Well the end that gets clamped on to the wire apparently did not like where it...
DAMN! if it was a NV4500 Id offer you some cash for it. That transmission should be an M50 close ratio so that is good. They are a real PITA to...
I am no expert on flathead engines by any means. But isnt this the same style of crossover pipe like for the ford y-blocks? In that is takes the...
When I saw the motor it was in a old chevy van kinda reminded me of a mystery machine it was even greenish. I almost shit myself when I opened the...
Do you still need the pipe? I am assuming that you still need it what I would do is to get some gas, acetone, epoxy thinner, etc. and take the...
I had a freshly rebuilt chevy 350 with a turbo 350 trans I pulled out of a junkyard it still had assembly lube on the rockers and still had the...
I would much rather use wintergreen oil it is available at just about any drug store. The plus side is it smells really good other than some of...
The guy that built the driveshaft has been doing it for many many moons. Everyone that I had talked to about a custom driveshaft pointed me to his...
If that were the case would it not also vibrate while in neutral too and not only in drive?
I dont know what the actual torque I put on them was but I took a wrench and tightened the nuts up then I stuck another wrench on that and torqued...
Hotrodprimer- Yes it was greased well I just had cleaned it up well and have had it taking it around to some people asking them if they have seen...
hotroddon-I have looked at the output of the transmission but I do not remember what that angle is. Mike51Merc- According to some of the...
There are some unusual wear patterns on the u-joint in a 1940 ford car. The car has a 350 with a 400 turbo in it there are also some vibration...
Separate names with a comma.
The Jalopy Journal