The Jalopy Journal
Carter M3528 or Airtex 3450. If you want a more typical looking "Ford" pump with the long lower chambers, Carter M6984. The Holley and Carter FE...
Mmmmm....Y block power....
The line can be cut & re-flared...I would (personally speaking) double-flare it as was the factory line. However...depending on how the line is...
Any way to tell what brand the old filter was, by scraping off paint or whatnot?
They usually sit "straight up", if that makes sense, rather than be twisted like yours. If you can, try loosening up the tank straps and pushing...
Are you going through the access hole in the floor? It's tight, but doable with a wrench to hold the fitting and a tubing wrench for the line....
This. Use a Napa Gold (Wix), or a Baldwin, or a Motorcraft, if the Wix isn't available. Beyond that, it's probably time to pull the pan and...
What weight of oil is in it (if known)? Also, what brand of pil filter?
Good guess, but Harland Sharp actually IS Harland Sharp. :D Harlan Fengler went on to become the Chief Steward of the Indianapolis 500 for many...
Yep. Now, who was he and who was his partner...and what did his partner go on to do?
When looking at the long history of Cragar, and all the changes in ownership, manufacturing locations, etc., nothing would surprise me anymore...
I owned two different sets of Cragars in the early '80s with the recessed oval slots...(shrugs)
Looking at the original Photobucket picture, it appears as if he has the later style unilugs with round washer holes, so he would need the round...
John Kelly's web site (with disc-in-action pictures: ) http://www.ghiaspecialties.com/
You should be using either round offset washers, or oval offset washers (depending on the particular wheel), if your wheels are unilug. It looks...
Separate names with a comma.
The Jalopy Journal