The Jalopy Journal
5.2 (318 ci) or 5.9 (360 ci) out of a 94/95 dodge truck with the 46 rh trans. The truck engine has a rear sump oil pan and the ac compressor and...
I know its a bit pricey but the vise mounted turret style flare tool from eastwood makes some nice flares even in stainless.
Posted using the Full Custom H.A.M.B. App!
I found this site a few years ago. I know it is geared toward car audio but it still has a lot of useful information about automotive electronic...
Does your rack have the long or short pinion shaft? Had the same problem on my 37 dodge with the motor mount being in the way of the long shaft,...
Fatman M2 installed. Thanks again for all the information from your experiences with the M2. When I figure out how to post a picture I will put...
Yes 1.75 Wide. They have 8 leaves with a total thickness of about 2.062.
Putting a MII up front.
At least there isn't a lot of wiring to check.
Pulled the trigger and ordered the posies.
I measure 24.625
I put a spring back in and jacked it up to a point where the arch measured 2.25" and got a measurement of 17" up to the wheel opening. If that is...
Shift Quality & Linkage Adjustment (Session 279) from the Master Technician's Service Conference
I think the liquid in a gauge acts as a damper for the needle. Slows the movement down when it goes from one extreme to the other.
Separate names with a comma.