The Jalopy Journal
Check polarity. May be wired backwards
Ground. Connect a temporary ground to the pump and see if that corrects the problem.
Your best bet is to invest in a strut spring compressor. It compresses both sides at the same time and is much cheaper than the Clamshell. Go back...
You can change springs without a spring compressor. Raise the front of the car and place jackstands under the frame behind the lower control arm....
I think you have identified it.
Does not look like any 28 Ford I ever saw. Can you show pics of engine and rear end? Is there any emblem on radiator shell?
The hot wire from the "headliner"should go to one of the 3 wires that you cut from the TS switch.
Something is not right. The pp should fit up to the flywheel without a gap. Pull the clutch out and see if it fits tight to the flywheel and is...
The picture at post 18 is the same as post 33, only it is reversed and enlarged. Interesting looking car.
Practice on a similar piece of scrap to get heat right. Practice always helps to get it right without making a small problem bigger.
Weld downhill with a side to side weave.
White truck Co. during a snow storm.
The old tools were made in USA. The quality of the imports is suspect. The manufacturers are relying on their reputation and giving us...
Bad idea. Back pressure creates too much heat on the exhaust ports. Will run way too hot.
Pick up the phone and call your friendly cam grinder and allow him to recommend the proper cam grind based on your vehicle, the use that you will...
Separate names with a comma.