The Jalopy Journal
@Kume Am I heading in the right direction on this? I would take any input (Especially from one who has done it before!)
I missed two pics. #11l shown with a small piece of particle board to hold vertically. It is also almost ready. will have to check for...
I took the camera to the shop this morning and got up to date pics. I believe that this is the fifth time that I have put this part together! I...
Four trunnions are required, two for each yoke. Bolts go in from the front. nrgwizard. Now those are real drawings! It would be great to get the...
May the Force be with you!
Torque washers. So that is what they call those things. I see signs of them on my stuff also. I got a friend out in the shop to make me some crude...
Yes, it would help with a full size old part, especially "B" (#11L). I am doing #11L because it is the only old one, that I have. Hopefully I am...
Next installment on sketches: "A" pillar R (#10R) It took three times to get a good pic. let me know if this is good enough. Having a little...
The 28 distributor still uses the spark advance, (just not as much) so take care of those hollow shafts! You can do whatever you want with...
You got the gas tank too!
Sorry that I have not been making much progress. We have been sort of under the weather for the last week and didn't want to get too far from the...
Tom on the pattern sills I did use the adjustable angle boards. If I remember right, it was very hard to clamp where the saw didn't want to cut...
?? at work?? Show how I mounted pieces on them? Tomorow I will see if I can get some pics. of the jig. (Mainly used to stand boards on end to cut...
Oh No!
Tom, your 21 3/8 from front bolt to second bolt is what I got also.? The extra length in the sill should not hurt because that end is somewhat...
Separate names with a comma.