The Jalopy Journal
YES!!! That’s exactly what I was looking for! I remember poring over each and every detail of that site years ago but I could not find it to save...
There used to be a several page site with detailed pics and info on the engine build, now there’s none, just info about Leo’s wreck, prior to...
I’m deeply saddened that all information on this car seems to have been lost. I recall reading thru page by page the custom machine work on the...
Good to know about the rms. Maybe I’ll put a new one in while I’m at it. As for here vs pirate4x4, I’m not on pirate4x4 (yet) and this project...
Or I can get a 10.4 with 10 splines for a 66 Chevy II with a 283...?
Rockauto shows 1964 Chevy II with a 230 I-6 using a 10” with 10 spline...? Sound right? Would that be tough enough for low-rpm crawling?
Only $39 on eBay for the insert
Here you go, several options for the friction plate replacement. May still need some machining work though to recess it into your aluminum....
If it’s 153 teeth, that is...
I’ll return your investment and find a way to make it functional!
So found the flywheel I need by searching 1968 Camaro 302ci gets me a 153t for only $54, but the clutch for that make/model is like 26 spline...
Dang, can’t beat $43 with a stick! I looked up the bellhousing number and it says it won’t work with a sm465, 4.65” bore vs 5.125” bore, but I can...
Is it possible to run a flywheel that came from a boat sbc? The name of the game with this build is cheap, and even used I can’t find a flywheel...
Oh maybe this image upload works...
I can’t upload a pic of my bell housing but it is an aluminum one with casting number 3858403 casted into it. No idea where it came from but has...
Separate names with a comma.