The Jalopy Journal
I'm also going to vote 180. Engine gets up to operating temp faster and runs better quicker. Engine temp shouldn't go up more than that if...
Had a 78 GMC with a crate replacement 350 in it, heard scraping and found the outer ring cutting into the timing cover. Also had a Mini Cooper...
Well I went through the entire post and I didn't see this so I am posting it. Title says unusual and I think a Maytag fits the bill. [IMG] [MEDIA]
If you aren't afraid of the job and maybe have a little experience with them, Weatherpack stuff. Here is a list of smaller connectors from 1-6 for...
I would check my engine design. flathead V8 has sludge traps in the crankshaft. Detergent oil would possibly loosen something you don't want...
I'm going with the fuel pump diaphragm has a leak from ethanol gas eating through it.
I call them Hardly Ablesons
Nice!
This was my understanding as well. Had something to do with galvanic response. Ahh, here it is. "It is partly a matter of convention and...
I came to say this. If the ground wire is original, the insulation is shot. It takes about an hour to pull the distributor, run a new ground and...
My understanding was that plastics were painted with a conductive paint and then plated the traditional way with copper, nickel and then chrome....
Another vote for JB Weld. Non conductive, used in electronics assemblies. Some youtube videos it's ridiculous how strong and durable it is for the...
Of course I'm not giving you a real testimonial but it's pretty common practice to glue rubber with cyanoacetate (superglue) when making seals in...
Resistor plugs! Almost nothing stumps me but I inherited an OT Ural that the old man "tinkered" with. After finally equalizing the carbs until it...
The third ones are the ones like the Termi's on a Ducati. [IMG] Here is a pic of a modified termi. You could leave the end open on the ones you...
Separate names with a comma.