The Jalopy Journal
My old shop was just down the street from toms house on loganberry street. we met back in the early 90s, huh that sounds like so long ago, I just...
Better late than never.
that 31 vicky is just f-ing bad ass, i want one. as for $75 and a bad deal , some guys want to be a gear head, others are, I have over 4000...
actually I have introduced myself twice, the first time was a few years ago, forgot my password, and I was having a hard time getting it back so...
factory detroit diesal turbo seals are installed dry with shaft savers but neopreme seals are greased,
yep, but i have the best deal on bearings and seals anywhere in the world, garenteed! www.deanblowers.com
how many sbc engines would survive 18lbs of boost?? Not Many.
for street use and mild drag raceing the shims are fine, most of the time you can assemble the blower without shims and get added clearance, I...
sbc with 671 and hydrolic cam should produce easy 450+hp just be sure and have good head gaskets and intake valve springs.
buy a small bore 671, a 471 will cost alot more , the snout is twice as much as a 671, the intake is allmost impossible to find, addaptor plates...
9/16 soft plugs hammered into the bearing plate works best, counter sink with ball of small ball peen hammer and larger hammer. front plate only...
the guy that wrote that article died a few years back acording to the owner of the website, again, Bad advise on building blowers.
Rob, your advice on building blowers is some what helpfull, I apreciate you useing my name and buisness for your tech article, however, you should...
just checking in to see what all you shade tree , gearhead bolt busting wonna go fast tire smoking bearing spinning flat tappet full race pumpkin...
Separate names with a comma.