The Jalopy Journal
Hi Looks like the needles are crushed. Take all rockers apart or send them back to comp. With those rockers I would check with comp if you have...
Hi Sorry to butt in here, and I won't tell him how to do this , but after reading all the posts I think you really need some one to help you...
Hi back in 1968 I twisted my input shaft 1/2 turn in my 68 Camaro and that is all I did to put a new on in. The flat spot is so it will go past...
no you do not
Hi When I changed the input on my m20 I did not have to disassemble the transmission. The input has a flat on the syc. ring teeth that lets you...
Hi Where do you live?
Hi Possible, but I would agree if it was 1 or 2 pipes but all pipes. There was some discussion about grinding seats for valve springs hitting...
What is your opinion the second oil problem?
Devmar Don't knock your self out. We all have been in your shoes some time in our life. I have a crank ground stroker sbc in my dragster I just...
Hi If this is correct I think he has 2 problems. There is way too much oil in the exhaust. That said If coolant The bottom end should come apart...
Hi I agree 100% with you, as I stated many times to disassemble. If for nothing than piece of mind. Some thing is put to gether wrong
Hi You have a 50-50 chance top end or bottom end. Only thing the bottom end is a lot more expensive. So as for the money the ratio changes. Good luck
HI So you have the heads off? Can't type fast enough
Hi Is that a pic that was given to you. and you put pistons in the block? Were the rings already on the pistons? We many years ago used to run no...
Hi If you are correct at 40% on every cyl. That is a contstant That something was put together wrong the same in all cyl (rings----- std pistons...
Separate names with a comma.
The Jalopy Journal