The Jalopy Journal
Cord 811 Posted using the Full Custom H.A.M.B. App!
Well in my case raising the motor by a 1" wont fix my problem i´ve tryed it yesterday. The middle tube wont hit just by shimming the donut so it...
Would Two hockey pucks do the trick ??? Otherways its time to spin a chunk of aluminium in the lathe Posted using the Full Custom H.A.M.B. App!
Btt Posted using the Full Custom H.A.M.B. App!
Hi Dick I bought a pair of Bob drake 48 truck pumps . Posted using the Full Custom H.A.M.B. App!
Hi there I recently bought a pair of fenton cast headers for my 37 ford. According to the ad they said to fit a 37 ford with stock steering....
Hi I have recently dissasembled my 1936 ford gearbox. Inspected it Cleaned it up replaced bearings and som other parts. It had the early...
Hey Thank you for all response.. I was planing to go under the x member just to clear the pedal stand master cylinder and brake pipe.. The...
Hi Need som advice here about building the left side exhaust on a 37 ford Wich is the best way to go. Through the x member stand or under the...
What kind of ballast resistor should i use....??? I cant se any specs in the users guide of the distributor ????
it is not a stock engine .....High rise Thickstun intake ,dual 97:s, mercury crank and a max 1 camshaft i thin k it will rev pretty good......
I know but i am planning to use a magneto when i have the cash for it meanwhile i want a new and fresh distributor for my 8ba....
Separate names with a comma.