The Jalopy Journal
Garage ? That would be nice. [ATTACH]
Holding off on vatting for now until I get some research done and my parts. There is no room for error due to budget constraints and parts...
Then there looks like rubber "grommets" around the oil galley ? [ATTACH] I think I need to wait until my rebuild kit gets here and I can see...
The reason I was gonna leave them in is because I've been tapping on a couple and they are set in pretty good. I did t want to mar the surface...
What about the brash bushing for the oil pump shaft though? Any ideas? I'm not sure my rebuild kit will come with a new one if I beat this one out
I'm getting new ones. I was gonna let them get eat up. Haha
I prolly need to get the oil pump shaft out because it had a brass bushing correct?
I've put some elbow grease in this block and I've decided it's going to have to be vatted. So, I'm building a "vat" Headed out to get a 50 lb sack...
[ATTACH] Pays the bills with a little bit of play money left over... Very little...
Yea my wife is pretty good with the leather stuff. She's just never done a door panel sized piece though and getting it mounted and all that. I'm...
I've been thinking about the direction I'm going to take the car. No trim. Flat blue ,white roof. Black walls with the stock hubcaps I found in...
Good info thanks! I got a cheapy harbor freight caliper. I'll check it out. My dad was a drag racer. We ran a bbc 468, we'd do bearing every...
Well I "have" a rebuild kit. Supposedly a master kit. I'm just waiting for it to get here, and it's free basically. Trading some labor . It's...
[ATTACH] I take that back, this cylinder has some rust and I can see where the rings sat. Also there is a small "gouge" hard to see in the pic....
[ATTACH]
Separate names with a comma.