The Jalopy Journal
Thanks to all.
Hey Guys, I need a measurement from the block of a sbc to the end of the pulley off the crankshaft, for a 3" belt, so I can my motor...
I have there long 4 bbl. intake, Headers, Valve cover.
Very well made, good service, and yes I would buy from them agine.
Here is couple of shots , more to follow.
Hey Guys, just to let you know I lowered the pinion 4* and it seems that all is well.
Thank You all for your help.....Mike
I will lower the pinion and put a shim under the trans. and see what happens.
Thanks to everyone who helped....Mike.
[ATTACH] I hope this helps, also its on a 4 bar link with coilovers...Thanks
when I measure my shaft its 5* up hill.
My shaft goes up hill to the pinion ? does that mater
This has been like this since day one
I know by looking that the rear joint is on more of an angle than the front u joint
I Don't know how to do this, could someone tell me how..thanks
Hey Guys...I have a driveline vibration for a couple years now, that won't go away, let me tell you what going on. 1938 Plymouth coupe, slant six,...
Separate names with a comma.