The Jalopy Journal
Awesome great job thanks for the info
I build custom headers but I cant seem to find anyone who builds them. Shouldn't be hard to make. Take 3 pipes that will slide over the pipes you...
Mig welding is pretty simple. I have the same welder so I will give you some of the settings I use. For 1/8 to 1/4 set the heat in the middle I...
Yes it will work. I box/plate all the way around on the ones i do
I just finished a 429 rebuild for a customer. I searched everywhere and didn't come up with much. The parts are expensive compared to chevy, but...
A short water is right on the cover. A long wp is about an inch to inch and a half away from the cover
No either head location will be fine. I believe they do make a 1/2 npt switch
Damn good idea
Heat does rise but there will be more heat at the combustion chamber than at the thermostat not necessarily a huge difference but a difference
Sounds to me like the tire shop didnt want to do them. I've mounted quite a few and have never had any problems. Gettin to balloon out on a 10...
Installing the switch in the head is the best location that is where the heat is transferred to the switch will react slightly quicker as opposed...
A nice highrise manifold and an edelbrock carb or a holley
Drain the oil out of it fill it up with atf let it idle for about 5 to 10 minutes and drain it then fill it back up with your favorite flavor of...
Sweet
Could be 2.02s measure the valves
Separate names with a comma.