The Jalopy Journal
So I just went out and re-adjusted the cable to make it tight at idle and really tight at wot. Take off is quicker with a hard, firm shift into...
Geometry should be correct. That part I am sure of. I used the carb throttle lever adapter and cable bracket recommended by Holley. The throttle...
When I say loose, I should elaborate. It is not floppy or anything like that. There is tension, but not much where as at wot it is tight with just...
That is what I have heard. I guess my big fear is doing the rebuild then shooting myself in the foot by making the same mistakes again with the tv...
Thanks for all the quick replies. It is a little loose at idle. Trying to learn on your own often finds yourself learning lots of misinformation...
Hi all, I've been combating an issue with a used 700r4 I have recently installed in my c10. I used the correct brackets on the Holley carb and I...
Get a buffing wheel and go to your nearest big rig truck shop and buy yourself a couple polishing bars of various courses. You will never go back...
I have them on my cj2a. Good off-road and on dry roads. They are like slicks in the rain.
The 350 in my Nova would backfire through the carb on acceleration and lacked power. I chased the problem for a good while until I found a few...
You could coat it with navel jelly and within an hour or two you will have clean metal to work with, you will just need to clean it afterwards...
I don't post much, but after reading through the rodders journal thread I thought I would give a shout out to speed and kulture magazine. Great...
You will spend more money spray painting a whole car than you will with a gun. Buy the $20 special harbor freight gun, summit has a very...
Eagle and scat both sell complete balanced rotating assemblies for right around $800. It is not cheap to have everything balanced. It cost me...
Separate names with a comma.