The Jalopy Journal
Not sure where some of the wild guesses come from...a bare block weighs 190-200. The variation comes from which foundry it came from. Yes, I have...
Just ran across their website and they appear to have alot of old stock. Rocco and Cheater's Speed Shop - Birmingham, Alabama | Hotrod Hotline...
It is good that you are asking questions; they are less costly than a pile of useless parts. Perhaps I should have first asked you to measure the...
I'd be a bit more focused on what to do for a front seal. You have a giant hole there....might need to make an alum bushing to emulate the tin so...
The 'real' one....? Let us know if you figure it out. Likely that most folks have made their choice, good or bad. And don't expect the 'bashing'...
...I think that we have our work cut out for us...;)
Great info in your post. Really can get confusing when two companies use the 'Johnson' name in their products name. The key for me is "Topline"...
They think they are still in business. Topline Automotive
Dan, Fair enough, we all have individual experiences. I rarely turn the rotating assembly enough after dialing in a cam to consider lifter...
Lifters are not going to spin when turning by hand. Now, stop turning it over and get some cam lube back in there. You could pull one or two...
When I was making the Hemi mounts I had one of the local steel suppliers cut, bend and weld everything. They did a great job but today I'm sure...
If anyone is in the Monterey, CA area this could be a good buy. Cadillac Edelbrock intake manifold - auto parts - by owner - vehicle automotive...
Check with @dmarv for current availability.
What is/was the donor? 1992 -up Ranger and Explorer should be near perfect width. Seems like the guys over at www.p15-d24.com have done this swap...
Separate names with a comma.