The Jalopy Journal
I have a diamond block B engine, it's got an un-counterweighted crank, an early A type oil pump that isn't supposed to have enough flow for a B,...
Burtz kit #0474 checking in.. [ATTACH]
Marvellous, can't wait to hear it roar!
I like that it's very neat, and just a simple turning job to make something similar.
Superb!
Thanks Dan, it's all bit scary as my deck is already a bit thin and wasted around the crack, what type of pin/screws did you use? I like the...
It's a weird problem. Had flattened springs on my stock '28 Chevy, adjusted the steering box and put correction wedges in which stopped the car...
Haha, yes I did think about relieving them all to match! Big crack in #3, repair in #2, crack in the middle of #1. Good idea about stepping up...
Being a banger rookie, I thought my Diamond block B banger seemed to run ok, except for some ticking that I thought was a loose tappet or two, so...
So only the RH thread to cut, should be easy enough. Next question, where's the best place to find a new reversed eye front spring, or possibly...
Thanks 31A
Thanks Rusty
Are these the ones you mean Phil? What are you using for a tie rod with these?...
[ATTACH] Yep putting the leaves back should make the shackle angle better, I think they are swaying and making the car feel unstable as they are...
The fuel inlet valve, the Grose type in new Stromberg carbs it has two ball bearings instead of a needle....
Separate names with a comma.