Hudson 308 rods in a GMC 6?

i think there was a H.A.M.B.'r who built a long-rod GMC for their HA/GR a while back using the hudson rods and chrysler flat 6 bearings. did a search but no joy.

i'm looking for particulars on this swap, center to center, rod bearing journal diameter and width, compression distance, deck height c to c on the GMC, piston choices, etc.

 

Tom Langdon built a 341 cubic inch GMC using the Chrysler/DeSoto six rods, I believe.

 

His name is Ron Golden. Get over on the HA/GR board, it's there- all 347 horsepower!! You'll have to ask him for particulars though.

 

Do you have the link to the HA/GR board?

 

Shame on you:
http://www.jalopyjournal.com/forum/forumdisplay.php?s=&daysprune=60&f=38

You can do a forum jump to get there. You have to scroll down to find HA/GR.

Thanks,
Kurt

 

Thanks - how in the world did I miss that?!

 

thanks all