Busy over the last week getting the firewall and gas tank ready for paint Here is the firewall, shot it early this afternoon ATTACH=full]2939653[/ATTACH] Posted using the Full Custom H.A.M.B. App!
and the tank along with the tail lights and brackets , sorry a little blurry only took one picture . Posted using the Full Custom H.A.M.B. App!
also Shot the inside of the rails over again This area wound up looking pretty dry. So I reshot it Posted using the Full Custom H.A.M.B. App!
It's a creme white from a t5 Volvo My son drives a car this color Posted using the Full Custom H.A.M.B. App!
Also installed the body welt This is self adhesive and has a wax paper like backing I started by taping it Down and pressing on the welt to cause an indentation in the wax paper I then made a hole punch out of a pipe sharpened with a sander Using a plastic cutting board I punched holes in the welt Posted using the Full Custom H.A.M.B. App!
Hit a bit of a snag Installing spark plug shields , hole for shield for 6 and 8 was not drilled and tapped Posted using the Full Custom H.A.M.B. App!
Bought an angle drill, and drilled and tapped the block did not want to pull the motor Worked out well Posted using the Full Custom H.A.M.B. App!
Never finished the drain pans for the trunk gutter Decided to work on that today Made a sheet metal tube Welded it to the bottom Posted using the Full Custom H.A.M.B. App!
Looked for quite a while to find a fitting for the floor Found these Volkswagen Beetle valve cover vent bolts A short vinyl tube Here's what the finished drain looks like Posted using the Full Custom H.A.M.B. App!
also worked on making a fan shroud today Used 18 gauge sheet metal Marked the hole for the fan Posted using the Full Custom H.A.M.B. App!
You're not worried that's going to block a whole lot of air from flowing through? The electric fan only operates when crawling in traffic or stopped, other than that the rad relies on flow. Just a thought.
Guys Been out of pocket for a few days The fan hits the water pump pulley Going to have to punt On the shroud all together Posted using the Full Custom H.A.M.B. App!
Made some progress over the last few days Here's the new fan mount setup Posted using the Full Custom H.A.M.B. App!
Wanted to use an early 60's gm air cleaner It is really large, too large to use without making it fit off center The air cleaner I found was a 2 barrel so I had to use a later 4 barrel base and cut the center out of it Made the center bolt offset as well Here's a shot of amount I had to move the hole off center to clear the a/c Posted using the Full Custom H.A.M.B. App!