The Jalopy Journal
SOLD
I have a few leftover parts for Schroeder Steering. A 14"pitman arm, a cut-off input shaft with keys and nut to retain gear, a support bearing for...
Riley 2.5L engine
Mystery SOLVED! It seems my "rocker cover" belongs to a 1949 Healey Silverstone[IMG]
that's why I think it might be VERY early on....
I'm thinking perhaps a VERY early Mercedes Benz.
I appreciate the input. Sarcasm is good.
The cover measures 18" x 4" x 3" tall.
Good morning fellow HAMBer's.[ATTACH] [ATTACH] I'm in need of some expert opinion. Yesterday I was given an old, heavy cast aluminum (seems too...
NOS 1961 Buick taillight lens. perfect condition. P/N TMC-753-RH....This is a GLO-BRITE SAE-STDB-61. Price is $15 plus the ride.[ATTACH]
When I got to the point of making floorboards for my last build, I began looking for a reasonably priced, preferably USED brake. I found one close...
who said I like it clean? LOL My carbs leak, my oil pan drips, my beer spilled...
yes, I think paper will be the BEST way to go.
yes, the bearings are sealed but still weep a tiny bit of red grease. I guess if the caps leak I will clean them up and silicone them with a...
yes, I know all about the liquid gasket alternatives, but is it really needed?
simple question, I just swapped out the rear bearing caps on my 471 GMC blower and realized there are NO gaskets under the bearing covers. Is this...
yep, the only real issue I had was a bad torque convertor, had to go to a higher stall, but that was a calculated gamble. The blown flathead...
I put together my AV8 several years ago and opted to go with a 700r4 behind my flathead. Coupled with a 4:11 rear, the low 1st gear does a fine...
slide a piece of wire through first, then PULL the springs through.
Here's my dirty-one ford.... [ATTACH] [ATTACH]
I use filters for commercial air compressors.
[ATTACH] Go TALL. More surface area = less restriction.
he has mentioned me sending a check, but that's still no guarantee that I get my parts. My point is the world is rampant with fraud and secure...
Now I will VENT. After weeks of research, and long online conversations, this morning my 2:1 multiplier is "In Stock" @ Quiktime...now the sleazy...
this was a batch made in NZ destined for the US 18 months ago.....where did they all go?
[IMG]
Yes, Ididit bought all the tooling and inventory, but I've been told (By them) that the ratio-reducer is NOT being produced currently and not in...
from the info I have it looks like the unit Quiktime sells is made by a guy in NZ. The plot thickens....
yes, I'm currently seeking a quote from Quiktime, but West Evans is very slow getting me pricing. Not sure why.
yeah, not much room to work with that's why I'm going this route.
Separate names with a comma.