The Jalopy Journal
Patina art by Mother Nature Try faking this one.... [IMG] [IMG]
I know this is an old thread, but my 2 cents on print being dead. After I got my email from TEN giving me my choices after they cut my SRM...
Anybody got a clue as to when the next one is going to appear on the stands? I just went to the publisher's site, the only web presence for this...
Subscribed, and thanks for taking the time off from your project to share.
Just stumbled onto this thread, (I was searching for some different pot metal rods) I got caught up in it and read it through. Kudos on everything...
Found a copy accidentally the other night at a Jewel (Chicago area chain) grocery store. Pricey, but I thought it good to support print that's...
You might want to check out this setup, he's in England and a panel beater/coachbuilder by trade, but is into traditional rods himself. He...
My question is in regards to my Watched Forum feature, not email subscriptions to individual threads. My time on the HAMB has been limited of...
That is a good 110V unit at a good price especially with a gas bottle. Later you won't have to upgrade unless you want to do chassis work and...
Ditto, although in my neck of the woods good parts guys are even scarcer than before. If you can't find one over there, the interwebs could be...
Have you contacted Bob and Arlo at http://wisconsinhotrodradio.com/ ? They did a lot of digging around a few years ago for WI car club...
Great thread, just subscribed. Thanks for taking the time to post.
My 2 cents, and I can't guarantee it, but I think the drum would fit behind the wheel on most of the dynamic spin balancers I have used. If so, I...
Thank you Shane, for an very worthwhile experience. I learned not only from the presenters, but from several of the other students as well....
Steve, real nice job on the hammer. Great way to get the exact look, feel, and balance you want in an heirloom tool to boot! As far as the weld...
Thanks for the heads-up on Boys of Bonneville, I loaded it up and previewed it, I am definitely going to watch it. I will also do a little...
These guys have genuine weldcraft at prices cheaper than a lot of guys carry knock-offs. It's an on-line outlet of an old brick and mortar, get...
Ouch! tough fees. Looks like a great start, keep up the good work. Agree on the pex in the floor, used boilers show up reasonably when you start...
I really like this thread, I'm a subscriber, great work so far. My kid works with bicycles, and years ago he turned me onto tubemitre.exe...
Many times when I have been doing the skip around method promoted so widely, I have unconsciously run a longer bead, (caught in the moment I...
I don't know how David did this, but heat bending is used to straighten damaged bridge beams. Some posts here on how to straighten bent frame...
this is from some random answer type site, but it sounds about right: Sylvania website says that the 1157 is a 26.9 watt bulb rated at 12.8...
IF the sender grounds to the tank (sometimes at a mount screw for the sender), then the tank must also have a good ground for the circuit to...
It's been a while since I troubleshot one of the older units, so I hope I can explain this correctly: They work on resistance. A lot of...
Subscribed! Is there some way, you, as the originator of the thread could check at least # of subscribers? I am not the guy who knows, but I am...
BTT: Just ran across Budd's story, I had linked through his airplane site: http://www.airbum.com/ looking for something completely different,...
The Lincoln is sweet, it speaks for itself. Nice score. I think it's all relative. If you had a huge building and it wasn't full yet, this...
That was a nice gift, I think I would check out its specs before I gave it away. Some of the professional ones are very good, don't jump to...
Separate names with a comma.