The Jalopy Journal
thanks and yes its a 52 chev coupe,, The body is in the shop and chassis is I my basement.. lol I would like for spring shop to punch leafs...
hi guys I am replacing the stock rear springs in the 52 coupe with shop springs. Since I am replacing stock axle with an 8.5 I am told I need to...
Hi guys ,,replacing the stock springs in the 52 BC . where do I get the shop to punch the center bolt hole to put the axle in proper place. I...
Like i said i have those parts but i need the piece from brace to where shocks bolt up
Hi guys... Havent been here in a while. Been workin on the 52 coupe.. I ordered repair panels from EMS and Mill Supply but except for tail pan...
Yes X3 that thin piece of steel should be in the throw out bearing gap too. It acts to keep fork and bearing snug yet allow movement. Jim...
Ditto Moon Rocket, my buddy let me use his 54 Caddy for mine, and he stayed for the reception ..:D:D:D:D:D:D:D
That"s what happens when you have the gear and talent to build..Great stand Bashing Tin..:D Are those casters rated for 1000 lbs. I used...
With proper ball joint press kit u should have nominal problems. Make sure the joint is straight and you may have to tap the press occasionally to...
The x heads do have the 60cc chamber and better intake runner... .02cts jim:D:D
Hi chainsaw,, if i were to guess i would say loose converter bolts or connecting rod knock Good Luck jim
Ya,, Gulfstream is right, build your own the way you want it... I have built 2 so far... Good Luck:)
Hey,, you may want look at 4x4 shifter boot rings too...My 80s blazer had a oval ring on the floor boot..hope this helps jim:)
HI.. no pics, but i had a great part year,,,sold the 327, bought 2 more in pieces, a B/w T10, 2sets chrome headers ,bare alum heads, and a 010...
Nice work Neal,, great recycling tech...:D:D
Hey RumbleVan,, welcome aboard, enjoy all the info here. lots of great people.... jim:):)
Hi Mark, those guages are what my dash needs to finish it... mine now are repainted,,, what a diff... Good Job jim:):)
Happy 52 day bruce.... ENJOY!!!:D:D:D:D:D
If those lower chairs are original its 69 or older. :)
hey Chemin,, there many ways, sockets and a hammer ,, sockets and vise .. or there is a u-joint press you can use....BTY dont clamp drive shaft...
HI ,,Charlie is on the right track i think, there is a rubber covered pin you reset on those valves . mine has it . While some one applies...
Hello Roy,, Great to have another Newfie on board... Welcome 52csb:)
Good to see Andy is in our thoughts . Rest in peace Thanks fitz..
Yes some fine cars around,but did you have to show the shiny 52...lol:rolleyes:
Welcome Vette 67, those #s do not jive with ones i have listed.....1402 ?? Good Luck 52 csb:)
Hi sam, i have a 4speed and 70 gto rear axle under my car.. The stock GTO drive shaft fit rite in there... Good Luck jim:D
Cleaned up set of 12" rotors/spindles my buddy gave me of a buick hearse. SCORE!!!:D:D:D:D
Oh so true forddude, always thinkin:):):):):)
Hi creeder, I would JB weld it ,Drill and tap to size Good Stuff.. 52 csb:)
Separate names with a comma.