The Jalopy Journal
This welder was my Grandfathers. I wound up getting it. I think its late '50's or '60's [ATTACH]
[attach][attach][attach][attach]
I know you were asking for old movies, but the new movie Boys of Bonneville would fit in just fine. Doubt it is available in 35mm
Here in UT we have a couple that are still around. Hires has 3 locations in the SLC area. The downtown and Sandy locations still have car hops....
[ATTACH] Thank you for your generosity
Just saw this thread. Great truck.
I found this link that will hook you up with Wolfman Radio Replays http://radiotime.com/program/p_105086/The_Wolfman_Jack_Show.aspx Besides the...
Email sent to all Senators.
Harvey Mushman.......King of Cool
Thanks for all the info. This thread got more replies then I thought it would.
I have a stock 396 in 58 Chev pickup. I am looking to change out to headers and 3" glasspacks, most likely the Cherry Bomb 12". My question is,...
Here is my 58. I just bought this 4 months ago. I would like to lower the front a bit and the rear quite a bit. It has 275/60R15 on it right...
We all have a past.........I am sure most have things we wish didn't happen. I know I do. The old saying comes to mind.....mind your own...
42hotrod.....what length of Schoenfelds did you use?
Here are 2 ideas to check.....You might have some air in the system that has not been pushed out. Or, it could be a clogged water passage.
The frame is a truck 1/2 ton short box 2 wheel drive
I am in need of someone to make up a set of custom headers for a special application. 58 Chev pickup w/396 all on a 1980 Chevy frame. Is there...
I just bought the truck in the pics below. It has a 396 in it. The frame is a 1980 Chevy Short Bed 2 wd. Looks like it was done pretty well....
This is a great deal. Thank you for making it available to everyone. My order went thru just fine.
Just bought this 58. First of its going to be lowered then we will work on the motor.
Thanks for all the replies. I had the same thoughts on the height.
Just picked up this 58 Chevy truck. It has a 396 in it with auto trans. Looking for thoughts on chop (3-6"), and also the...
If you purchase a tool box from a private individual that is deliquent on the payments to the tool dealer then I have heard of cases in which that...
Salt Lake Chrome does a pretty good job. If you need alum polished then go to Metal Masters in Murray.
I think tow truck would be very expensive. As the guy is going to want paid both ways. You might try to find a trucker that has a flatbed that...
On my faucet in the garage I have cold & hot. If I need some hot then I turn up the Hot Water Heater then run it thru my pressuer washer I got...
Beartooth Hwy in Montana.
Drag Racers
Flames and everything........
Separate names with a comma.