The Jalopy Journal
Hey guys, before I blast the remainder of 65 year old door art off of my door, I need to find a talented artist who can capture the design and...
SOLD
Oh, man! This alone makes 2014 worthwhile. Thanks for sharing.
Oh, yeah: subscribed! Post lots of pictures.
I love Packards. Can't wait to see how you integrate tail lights.
Well, lets see. What engine are we talking about here? Also, does ww refer to the carburetor? The crankshaft pulley should have timing marks on...
Dang! Where was this distributor conversion thread when I needed it? I used the slant Six Forum for my conversion information. The 230/slant...
Great tech article. Thanks for sharing. I'm glad you are posting here, but if your gonna survive you have to wear your big boy pants. Self...
Bump for the night owls.
One option would be to mount two separate master cylinders controlled by a toggle assembly. One example is the Wilwood Pedal Remote Master...
For the best terminals, buy what the aircraft guys buy. Thomas and Betts, also Tyco are two brands worth taking a look at. If you were to go this...
What we need to do is get this problem out of the introduction of new members. Find your way to the main H.A.M.B. discussion forum. There you will...
Your problem is most likely ignition, or fuel, but as tassiepete said, it could be any number of problems. These cars can be a lot of fun in their...
For the 230 it is 1 5 3 6 2 4
http://ecihotrodbrakes.com/discbrake_kit_components.htmlI installed aluminum residual valves on my truck, and had leaks that I could not stop....
Pressure Relief Valve Diagram
I vote yes! 1. .053, will allow for a pretty good squirt of oil at 40--60 lbs. 2. This is a bypass filter, not a full flow. Therefore, the oil is...
This should help. Be sure to plumb the filter correctly. Some filter "IN" at the top and "OUT" at the bottom, while others are just the opposite....
http://forum.ww2dodge.comYou may want to check in with the good folks over at the WWII Dodge Forum. There should be marks on the crankshaft...
Here is a picture of a Dodge military engine, but the fuel pump heat shield should look very similar on the Windsor 251. The shield attaches to...
What size engine is in the Windsor? I would trace the fuel line from the tank to the carburetor, and replace all rubber hoses. You could have a...
Yes, just a metal tip. You use your fingers to make the adjustment, never a screwdriver as that would apply too much torque and damage the needle.
Chrysler used their own differentials. Depending on your model designation, you probably have one of the following. B series used 3.73:1, 4.1:1,...
To my knowledge, no one.
Does anyone make an hei style distributor to replace the points? Some guys make their own. If you are talking about the 230 six, you can adapt...
What model 1954 Dodge truck is it? There were two different models that used a three speed. According to the Dodge Truck Service Manual,...
Using Cunifer line, my Mastercool tool left marks that ruined the seal. Switching to the FedHill tool almost solved my problems. I found that I...
Don't know. Have you called Wilwood Tech? For an easy fix, I'd dump the pressure switch for a mechanical, pedal actuated, one.
Renu Unless the company goes to crap, any problems are theirs.
Made for Cat by Deka. According to Caterpillar specs, the plates are glued in place. That minimizes the damage caused by vibration. Deka also...
Separate names with a comma.