The Jalopy Journal
Bob, Are you needing just the handle that you can bolt to your exsisting linkage with 2 bolts? Or the entire linkage with the shifter handle that...
More trouble than they are worth ! J.M.O.
Makes Ya think the windshield is ready to pop out !!
UPS never looked so good !!
Sounds very much like what I did with mine in 68' and you nailed it with the trading the experience!!
Too many car & parts hoarders these days don't help,but there are viable options,not all of us can find 33-34- Fords 40-41 Willys laying around to...
Same as the above,try rotating the tire 180.
That is the best advice to answer the question I have read yet,other than crunching some numbers with pen & paper.
What Fred said,otherwise it will just happen again, right?
Nice job, too bad that when someone posts good Tech Info. on here there ALWAYS has to be a few clowns to start a small riot...... Now I will get a...
THANKS H.R.P. I WAS NOT SURE WHERE TO POST,JUST WANTED TO GET THE WORD OUT.
Not sure how many people got the news on this ,but E - Bay has been hacked & advised people to change their password !! Sorry if this is posted...
I am not sure if using a propane torch is getting enough heat applied to the bolts ,and or head area to do the job,you need Oxy Acy to put some...
The gasoline we are buying today , I would think shelf life is 3 - 6 months if your lucky,it might still run an engine but what type of deposits...
What squirrel said ! ^
What is the inside diameter of the holes in the axles? As "gas pumper" stated you may need to enlarge the hole. Pressing the studs into the axle...
Sounds as if the shifter linkage is just not adjusted to engage the linkage on the transmission. Hang in there you will get it.
Everything said has been spot on, I only wanted to ad that back many moons ago when I worked in a " Full Service Gas Station" where everything car...
I still remember taking my 55 out for the first time right after switching it from a small block to a 427,back in 1970. Open headers 4:88's 4...
I have had issues like this & have been turning wrenches for a loooong time,if you can afford about $35.00 invest in a good vacumn gauge,setting...
Fel-Pro used to make a rear main seal that was known by (A good parts counter man ) by the nick name of the " Grey Seal " I used them a few times...
Also since it was not mentioned,and I am not saying this to make you look stupid make sure you are spinning the pump clockwise !
Save yourself all the grief & go with 9" or Dana 60. If you are after the period correct look 59 -64 Olds. Pont. setup ,but those are getting into...
Switched from Grundy & went with Hagerty. also added the Hagerty plus for $30.00 gives you unlimited flatbed towing ,road service & much more.
What Fenders said , & you will be just fine.
You have to also consider the problem could be in the lower end crankshaft seized due to bearing & or rod failure,sorry no quick fix for that one....
Have four of them ,and they have saved me a lot of $$$ on batteries over the years.
Without a doubt a car to be saved,looks like you have 1/4th the battle won given the fact your getting a new 1/4 panel,some labor of love & your...
I had two car covers from Cal.Car Co. about $279.00 each they lasted less than 18 months & rotted away to $%^& , the customer service flat out...
Separate names with a comma.