The Jalopy Journal
I made some L shaped hooks from some 1/8 brazing rod and attached some mono fishing line so they would pull on the side panel hinge loops. It...
I made a simple boom device that fits in my truck reciever hitch. It uses a come a long for lifting. It is made off center so an engine can be...
No Different width, curve at the cowl, mounting holes, attachment system.
I drilled the holes so that the nuts could be hammered in. I welded them in and ground them flush. I did this to my 32 3W in 1970 and it has been...
I posted a thread about this design before. Not much interest. I have better pics now. I hope it is of interest as it really works great and is...
I had a great experience with him! I was at a rod run. I don't remember where, Maybe Memphis. He came over and looked the roadster over very...
Thanks I will try acetone.
I have a nice Hollywood tag light. It has some thin primer paint on it that lacquer thinner will not remove. I assume that it is epoxy. What can I...
That rusty tube is in fact the pry bar for bending them outward. The very end part grabs the plate lip and the middle part pushes near the center...
I have a method of checking backing plates for warpage. The stuff is old and can get bent. I attach a strap to the hub and measure thru a hold in...
In the late 60's, I took a huge column from a Riviera and put in my 32 3W. It was a chrome tilt affair and had a very big tube. I cut the tube off...
Absolutely nothing. If it shows a seam, a little sanding will fix that. I have always used cheap flanged sealed ball bearings from a hardware...
Up please
I have an old sofa. It is a very expensive top of the line big sofa. The leather is still in fine shape. I believe the leather could be used for...
Very nice coupler. There are a couple of small worn spots on one of the halves where something got in it during installation. The inner cone and...
Extremely nice aftermarket U-Joint. I can not detect any clearance at all in the joints. It has a little surface rust. A Evap O Rust dip or just a...
Bttt
These fit the 315/325 Dodge hemi and polly engines. They also fit the 330/341 DeSoto hemi and polly engines. They are .010 oversize. They are...
Delete
Bump
It is a 37- 38 housing with a 39 fork. I had the same setup once. Cost me a set of gears. I got in first and second at once. I bought a 39...
[ATTACH] I made a Hurst style mount. I did enlarge the bottom two pairs of cover bolts to 3/8”. I made a brace across the top because the bottom...
Cancel
New Old Stock!! Never a bolt in it. Look at the pics with bolt holes and see no witness marks. Adapts the Y block 54-64 Ford engines to the early...
I put them in my 32 5W. I loved them. It had a 276 flat motor and 19 tooth close ratio gears. It climbed my steep hills better than the 241 hemi...
Separate names with a comma.