Register now to get rid of these ads!

Technical Throw out bearing question

Discussion in 'The Hokey Ass Message Board' started by bobg1951chevy, Feb 24, 2018.

  1. I have a '51 Chevy, with an open drive line conversion.
    Still a 235 6 cylinder, later model 3 speed stick, with a Ford 9".
    Question came up as to which throw out bearing is in the car ..... a long or a short bearing.
    What determines which throw out bearing (long or short) will be used ?
    Thanks !
     
  2. squirrel
    Joined: Sep 23, 2004
    Posts: 46,870

    squirrel
    Member

    the type of clutch. The diaphragm pressure plate uses the long bearing, the finger pressure plate uses the short one.

    Most new clutch sets these days include the appropriate bearing.
     
  3. Jim, thanks very much.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2020 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.