Register now to get rid of these ads!

Customs tail dragger kit installed... check

Discussion in 'The Hokey Ass Message Board' started by chigger, Jun 12, 2011.

  1. chigger
    Joined: Jan 30, 2009
    Posts: 169

    chigger
    Member

    Finally got around to installing a Gambinos tail dragger on a 1954 chevy belair frame. now its off to the brother-in-laws to meet with the body. just a few tweaks left to do to it, Then the bags.
     

    Attached Files:

  2. Midwest Rodder
    Joined: Dec 7, 2008
    Posts: 1,768

    Midwest Rodder
    Member

    lays nice, not much support for your bottom bar, only a small peice of angle. I'm not going to bash you but are you going to add more support to it?
     
  3. chigger
    Joined: Jan 30, 2009
    Posts: 169

    chigger
    Member

    part of the tweaks.. have to get more metal.
     
    Register now to get rid of these ads!

  4. Midwest Rodder
    Joined: Dec 7, 2008
    Posts: 1,768

    Midwest Rodder
    Member

    ok, I was hoping you just had it in the first stages, Looks good so far.
     
  5. resqd37Zep
    Joined: Aug 28, 2006
    Posts: 3,217

    resqd37Zep
    Member
    from Nor Cal

    Ain't quite low enough! :D
     
  6. MEYER8821
    Joined: Aug 25, 2009
    Posts: 189

    MEYER8821
    Member

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2020 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.