Hot Rods SMALL BLOCK FORD 4.71 SUPERCHARGER LOWER INTAKE

does any one have or makes a 4.71 supercharger lower intake manifold that will work on a small block ford ( 289 ) i had the 4.71 supercharger on a 350 chevy in my kit car so i brought a 1965 ford 289 engine i needed a 1973 or older engine in my kit car so it would be emissions exampt dumb new law since 2016 when we adopted california emission laws if u have on let me know and one question why can't i use a small block ford 6.71 intake because i have the plate the 4.71 bolts to if any one knows please let me know
oscar

 

dyers supercharger in summit illinois maybe

 

I can't help, but how does the belt driven input clear the front mounted distributor?

 

it's already set up for a small block chevy, it would be easier to go with a 283

 

1/4 to 1/2 plate , Single plane preferred or dual plane single four intake,
Or 6:71 intake & plate , you can move blower forward , distributors going to be a problem but can be worked around,
4:71 going to need a long drive snout ,
You can use crank trigger add 4 more magnets , use coil pack per cylinder & a box ,,, there other ways to make all this work , Think out side of the box , & just not all bolt on ,
You could add your blower to your lawnmower tractor if you
wanted too!!

 

Right angle drive distributors used to be a thing.