Register now to get rid of these ads!

Technical Question about pontiac shark fin mouldings

Discussion in 'Traditional Customs' started by Devin, May 16, 2015.

  1. Devin
    Joined: Dec 28, 2004
    Posts: 2,351

    Devin
    Member
    from Napa, CA

    I'm thinking about Pontiac shark fin trim for my 50 chevy coupe. I was wondering how the trim connects to the rear window beltline trim? I also wanted to know if anyone has adapted the 4 door trim to a 2 door or coupe? I've never been up close and personal with this stuff so any advice is appreciated.
     
  2. jeffyg82
    Joined: Dec 23, 2013
    Posts: 108

    jeffyg82

    The original belt molding gets trimmed and the shark fin overlaps I'll send so pics when I get back to the shop I just aquired a set and will be installing them on my 53 Chev hardtop very soon
     
  3. Devin
    Joined: Dec 28, 2004
    Posts: 2,351

    Devin
    Member
    from Napa, CA

    That would be helpful. Thanks!
     
  4. jeffyg82
    Joined: Dec 23, 2013
    Posts: 108

    jeffyg82

    Hope these help let me know if you need more
     

    Attached Files:


  5. Wouldn't the entire Pontiac belt trim just bolt on using the factory clips? The body is stamped the same under it.
     
  6. Devin
    Joined: Dec 28, 2004
    Posts: 2,351

    Devin
    Member
    from Napa, CA

    That's a huge help
     
  7. Devin
    Joined: Dec 28, 2004
    Posts: 2,351

    Devin
    Member
    from Napa, CA

    What I was thinking was using a set of 4 door trim pieces on my coupe and wanted to figure out how the shark fins would integrate with the rest of the trim.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.