Hi all. I am working on my 31 a body. The wheel wells need work so I got some patch panels and they aren't even close. My main problem is the rear because they curve in to meet the rear subframe crossmember., and the repo's don't. My left side is rusted pretty bad in that area. Just wondering if there is a good source or if these are all generic? If so what are some solutions that have been used. Would sure be thankfull for any help.
Your wheel wells look to nice to cut out. Unless the other side is a lot worse, I'd just cut out the rust and patch as needed. I've saved a whole lot worse.
The Jalopy Journal
