Here is my Polished Aluminum Gas Pedal Assembly. This piece is made of 6061 aluminum with 304 stainless hardware. The pedal is approximately 8 inches long with a 4 inch linkage arm which is then ran to your carburetor setup. The linkage arm has a pilot hole on the end so you may accurately drill to whatever size you need to fit your linkage application. The mount utilizes two stainless screws to mount to the firewall and holds the moving assembly with a bronze bushing. As always, made here in Minnesota USA by myself personally with the highest quality and attention to detail. Shipping is free to the USA but can also ship internationally. Shoot me a pm with any questions or check it out at my website https://nystromperformance.com/collections/automotive-parts