Register now to get rid of these ads!

Part diagram needed... Flathead related

Discussion in 'The Hokey Ass Message Board' started by devotion, Dec 9, 2012.

  1. devotion
    Joined: Apr 15, 2009
    Posts: 193

    devotion
    Member
    from idaho

    Just picked up a 1938 flathead and am trying to niece together the clutch. Does anyone have a diagram of that clutch set up? Thanks in advance... I can find one for the later 8ba motors, but not for this older one.
     
  2. Johnny-B-Bad
    Joined: Jun 19, 2005
    Posts: 1,019

    Johnny-B-Bad
    Member

  3. devotion
    Joined: Apr 15, 2009
    Posts: 193

    devotion
    Member
    from idaho

    Well shit. That's the one.
     
  4. devotion
    Joined: Apr 15, 2009
    Posts: 193

    devotion
    Member
    from idaho

    Is that clutch disc 9''?
     

  5. Johnny-B-Bad
    Joined: Jun 19, 2005
    Posts: 1,019

    Johnny-B-Bad
    Member

    No idea but I think it would be the same for all of them.
     
  6. devotion
    Joined: Apr 15, 2009
    Posts: 193

    devotion
    Member
    from idaho

    The reason I'm asking is that I have one off a 49 flathead and was hoping it will work
     
  7. Bruce Lancaster
    Joined: Oct 9, 2001
    Posts: 21,682

    Bruce Lancaster
    Member Emeritus

    There are a bunch of truck, passenger, and merc clutches for late flatheads...if it is a Long (like the one shown) and is Ford passenger, and is probably 9 1/2 and has fingers too closely spaced to work with early Ford throwout any way. Some Merc and truck setups are compatible with early trans throwout.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2020 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.