Projects Model A Build

1. Second coat went on smooth, I will block this good then seal it and be done for the summer, just going to drive it the way it is for a bit

 

Wow, very cool and your fab work is over the top. Great job.


Sent from my iPhone using The H.A.M.B. mobile app

 

Thanks a lot

 

Made new door skins, gapped the trunk lid and roll pan, ready for body work and primer !

 

Made a new pitman arm for the model a

 

Side shot, wheel base is 107

 

Season is over here in Iowa

 

Havin fun in the A

 

Model a stuff

 

Model a progress, took it out for a cruise, got a low speed death wobble when I hit a bump... smooth as butter at highway speeds tho

 

I have not seen a ribbed water pump before, where did you get it? Thanks Frank

 

Speedway motors sells this one

 

Thanks

 

I like the ribs on the exhaust. very cool

 

Changing the front end setup on my model a

 

Nice! I selee some Basss influence in the new set up. Dig the ribs in the headers don’t see that often at all. Nice job.

 

Weldin

 

Looking good

 

Looks good. Being a banger guy with vibration concerns
I used the stock motor mount to get the rubber. Do you have any rubber in yours?

Charlie Stephens

 

Hooligan!

 

I don’t notice it, but the car is a loud go cart so idk what to do other than hang on tight and hammer down