I was close to having my 52 Ford PU project fired up before leaving for work. I got a little over a week and half till I head home from the Rig so I am trying to get the info I need before I go home. My FMX in the truck is one that had a factory column shift with the trans arm pointing down. The factory floor shift models have the arm pointing up. I got a FMX Gennie shifter to go into the truck. Their shifter is made only for the arm pointing up. I am going to build a adapter to bolt to the arm to make it go up but need to get an idea of center to center length of the arm that goes up. Do any of you have any pictures of the ARM and/or could check the center to center length of one you may have? This is what I am working with right now, 302/FMX combo for a daily driver.