Working on the '50 F1 today, finally cutting out the original floors, I'm in the garage, got everything ready to go, compressor finally shuts off so I know I have enough air to cut the whole floor with the plasma cutter. Start cutting, about 12" into the work and the plasma cutter stops, blinking air light.. not enough pressure.. I check my pressure gauge inside, it's at about 60psi. So I listen for the compressor, no noise coming from the compressor house outside.. weird. I go outside, the pressure gauge on the compressor is at 140psi, almost full tanks.. that's weird. Then I check the dehumidifier, it's frozen solid!!!! I know you people up north must have this problem all the time, but I'm in Texas, it doesn't get cold up here.. I want to work on my car, not on my tools. Sorry just venting.