Customs Drive shaft info

Is there any drive shafts to 727 torqueflite big block to Danaher 44 rear end .factory drive shafts.

 

I expect you might find one in an International pickup truck

 

That's I'm putting 361 big block and 727 in my 52 Hudson and using original Dana 44 rearend

 

Go to the " C bodies only site" those guys will know.

 

Thanks

 

It's a matter of having the correct slip for the back of the transmission and having the correct yoke for the ujoints size. Dodge used two sizes back then, a 4260 and a 4290, you can get yokes for either size for a Dana 44 or a conversion joint to go from one to the other.


Sent from my iPhone using The H.A.M.B. mobile app